LED uses a fraction of the power of halogen and lasts years longer, but the saving is only half the story. Where the fittings go, how warm the light is and whether the beam suits the room decides whether a space feels comfortable or looks like an office. Too many downlights in a grid is the most common mistake we are called in to fix.
Charlie Sparks plans the layout before anything gets cut into your ceiling. We match colour temperature to the room, place fittings around how you actually use the space, and specify dimmers that are compatible with the drivers, which is the usual reason LED lights flicker or buzz after a DIY swap. Old halogen transformers are removed rather than left in the roof space, and the work is tested and certified.
Good lighting is design as much as electrical work. We plan the layout with you first, so you get the result you pictured rather than a ceiling full of holes in the wrong places.
Licensed electricians who plan the layout, colour temperature and beam spread before a single hole is cut.
Dimmers matched to the LED drivers, so your lights dim smoothly instead of flickering, buzzing or dropping out at the low end.
Halogen replacements, old transformers removed from the roof space, and fittings installed to the required clearances from insulation.
Downlights, pendants, strip and cabinet lighting, outdoor, garden and sensor security lighting for homes and commercial sites.
We install and upgrade LED lighting right across Sydney, covering downlight replacements, feature and pendant lighting, outdoor and security lighting for homes and businesses in these areas.
